It appears you have not yet registered with our community. To register please click here...

Ford Zetec-S Owners Club Ford Zetec-S Owners Club

Go Back   Ford Zetec-S Owners Club > BLOGGY

Notices

Conversation Between BLOGGY and Mackay780
Showing Visitor Messages 1 to 6 of 6
  1. Mackay780
    January 25th, 2014 19:16 PM
    Mackay780
    dude before you disappear from this site for good. can i have the contact details for the company who made the driveshafts for you? will be needing them in the next couple of months
  2. Mackay780
    May 10th, 2013 04:09 AM
    Mackay780
    thats what i was thinking/hoping. sweet. will get that sorted when i am back in the uk. i spotted the mounts on ebay and you should have the cash via paypal by now. looking forward to getting home and sorting all this out now
  3. BLOGGY
    May 9th, 2013 20:50 PM
    BLOGGY
    Hi Andy, right ideally you need both sides of driveshafts off a Fiesta ST. That includes the solid driveshaft section on the drivers side that bolts to the back of the engine block. So you need that mount with the shafts. You then just swop the cv joints off the ST shafts onto the new driveshafts. Then they will bolt into the original mk4 steering knuckles.
  4. Mackay780
    May 8th, 2013 04:33 AM
    Mackay780
    has it been less than a week? time moves strangely over here. thats brilliant then dude, when i get chance i'll buy them straight off, would you mind sending me a message when you do list them? with ref to the drive shafts, thats fine, you get what you pay for at the end of the day a? so for these drive shafts i will need to track down the fiesta ST joints for; the point where the shaft enters the gear box, the drivers side where the shaft changes direction. and do i keep the standard mk4 knuckles for where the shaft meets the hub?
    cheers dude, will let you know when i am ready for the shafts
  5. BLOGGY
    May 7th, 2013 21:07 PM
    BLOGGY
    Hi Andy, been away for a long weekend will relist them for you. The driveshafts can be made up they take 3-4 weeks to be made up bare in mind that they are just the shafts they are designed to work with the fiesta ST CV joints inner and outer as these are bigger and stronger than the Zetec-s mk 4s. I have spoken to the company that made them for me. They have gone up 10 since I last had them; but its a while back so not to bad works out at 195 per shaft.
    Thanks Paul.
  6. Mackay780
    May 4th, 2013 15:56 PM
    Mackay780
    dude, have replied to you on ebay, can you get back to me ASAP about the engine mounts? want to get a set fitted pronto! cheers andy

Powered by vBulletin®
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
PLEASE NOTE - PERSONAL ABUSE, ABUSE AGAINST THIS OR ANY OTHER WEBSITE WILL NOT BE TOLERATED. OFFENDERS WILL BE MODERATED OR EVEN BANNED.